EPDM
EPDM is the weather-seal material — the choice for outdoor exposure, water and steam, where ozone and aging would wear other rubbers out.
Typical Properties
| Hardness (typical) | Typically Shore A 30 to 90 |
|---|---|
| Temperature range (typical) | Typically −50°C to about 150°C |
| Key strengths | Excellent resistance to weathering, ozone, UV and steam; good for water and water-based media; keeps flexibility outdoors over long service. |
| Limitations to note | Not suitable for oils, fuels or hydrocarbon solvents — for oil service, NBR or FKM fits better. |
Values shown are typical ranges for the material family. Actual values depend on the compound and are confirmed from the material data sheet for your order.
Typical Applications
- Weather seals — doors, windows, enclosures and housings
- Water-system seals — valves, fittings and water equipment
- HVAC gaskets — air handling and ducting
- Diaphragms — water and air service
What to Specify in Your RFQ
- Hardness — Shore A value your application needs
- Dimensions and tolerances — from the drawing
- Operating temperature — lowest and highest the part will see
- Media contact — water, steam or air; state it plainly
- Outdoor exposure — UV and weather load, if any
- Quantity — trial batch or batch volume
Send the drawing with the specification — hardness, dimensions, operating temperature and media contact decide whether this material fits, and we confirm it from the data sheet before molding.
Compare Materials
Silicone (Solid / HTV)
Solid silicone rubber (HTV) for gaskets, seals, grommets, boots and covers. Typically −60°C to about 230°C, with excellent weathering, ozone and UV resistance.
LSR — Liquid Silicone Rubber
Liquid silicone rubber, injection molded for precise, thin-wall and complex parts in consistent batches.
NBR (Nitrile)
Nitrile rubber for oil seals, O-rings and fuel-system parts. Typically −40°C to about 120°C, with good resistance to oils and fuels.
FKM (Fluoroelastomer)
Fluoroelastomer for fuel, chemical and high-temperature sealing. Typically −20°C to about 200°C, with strong resistance to fuels, oils, chemicals and heat.