Transfer Molding
The middle route — suited to parts with metal inserts or bonded components, at medium volumes.
How It Works
A measured charge of material is placed in a pot above the mold and forced through runners into the closed mold cavity, where it cures. The closed mold gives better control of flash and dimensions than open compression molding.
When It Fits
Medium volumes, parts with metal inserts, bonded components, and parts where flash control and dimensional consistency matter more than compression molding allows.
What to Know Before You Choose
It sits between compression and injection molding on both tooling cost and volume. If the part has inserts, say so in the RFQ — insert design and bonding are confirmed per drawing.
What to Specify in Your RFQ
- Drawing or 3D file — dimensions, tolerances and insert details
- Material and hardness — silicone, EPDM, NBR or FKM, Shore A value
- Inserts or bonding — metal inserts or bonded parts, if any
- Quantity — trial batch or batch volume
- Operating conditions — temperature and media the part will see